cPRO camin - command mode
unlock your wireless potential
The cPRO camin can now switch from master to client mode at the push of a button
What is command mode?
This unique feature allows you to use any cPRO camin as a master or client, at the push of a button to create a wireless solution for ANY LBUS controller.
Simply connect your non-wireless LBUS device; i.e. pan-bar zoom, steady zoom, Master Grip or OCU-1 to the cPRO camin, power up, and set the camin to “client”. The cPRO camin will then transmit wireless command signals to the “master” (cPRO camin/cPRO motor) on the camera-side.
Wireless applications for robotics and motion control are possible without any additional accessories (e.g. LCUBE-1) through the cPRO camin`s CAM to serial interface.
Add the cPRO camin to your LCS inventory and discover a new world of wireless possibilities.
Looking for MORE? The cPRO camin can even increase your LCS wireless range. Simply connect 2 cPRO camins with an LBUS cable, one set to client, the other one set to master and create an RF repeater to achieve a wireless range of up to 2,000m.
How to switch from master to client mode?
To switch between master and client, simply press and hold the upper button on the cPRO camin for 3 seconds. Then select master or client with the up/down buttons and wait for 5 seconds to enable the function. (command mode is working from software version 3.0.)
cPRO command mode to add a non-wireless device to your wireless network:
Connect any device to the cPRO camin, add power and make it wireless in seconds.
NOTE: Up to two wireless client devices can talk to one master (cPRO motor or cPRO camin).
cPRO command mode used to create a range extender:
Simply connect 2 cPRO camins with an LBUS cable, one set to master, the other one set to client and create an RF repeater to achieve a wireless range of up to 2,000m